This article mainly introduces:

Burma hydraulic cylinder,tailboard balance cylinder manufacturer,tailboard balance cylinder

(Burma tailboard balance cylinder,produced by Hengyu Hydraulic Cylinder Factory）

tailboard balance cylinder are widely used in Burma，because of no need for deceleration device，long service life，excellent fatigue and impact resistance.So our company has designed tailboard balance cylinder for customers from Burma.

Introduction to tailboard balance cylinder:

Because of the slightly complex structure of the buffer tailboard balance cylinder, sometimes there will be problems, such as when the tailboard balance cylinder with the buffer device is started in reverse, the piston often stops temporarily or reverses. Elimination method: The orifice of the check valve is too small, so that the amount of oil entering the buffer chamber is too small, and even a vacuum occurs, so the above fault phenomenon will occur when the buffer plunger leaves the end cover. In this regard, the orifice of the check valve should be increased.

When the piston speed of the tailboard balance cylinder is high, the steel ball of the check valve flows with the oil flow, so that the valve hole is blocked, and the tailboard balance cylinder moves irregularly. Elimination method: Replace the steel ball with a cone valve or spool with a guide shoulder.

At the rated pressure, the thrust of the tailboard balance cylinder is determined by what factors: at the rated pressure of the oil pump, the work done by the tailboard balance cylinder is related to the diameter of the tailboard balance cylinder, but not to the stroke of the tailboard balance cylinder. Moreover, the larger the tailboard balance cylinder diameter, the larger the area, and the greater the pressure obtained. To this point, we should have a correct understanding and clear understanding, so as to avoid problems in the use of the tailboard balance cylinder.

If the piston rod and tailboard balance cylinder are stuck or the tailboard balance cylinder is blocked, at this time, no matter how to operate, the tailboard balance cylinder does not move or has little action. At this time, check whether the piston and piston rod seal is too tight, whether it enters the dirt and gum deposits: whether the shaft line of the piston rod and the tailboard balance cylinder is in the center, whether the wearing parts and seals are invalid, and whether the load is too large.

Answers to some questions about tailboard balance cylinder:

How to control the speed of the hydraulic cylinder?
The speed of the hydraulic cylinder is only related to the flow, so the control speed is to control the flow of the hydraulic oil, which is generally adjusted by the throttle valve in the system.

How to remove the air in hydraulic cylinder?
Connected the cylinder to the system, and reciprocating move with full stroke several times, then the air can be eliminated . There is also a clunky method as follows: first remove the rod cavity oil pipe, connect the rodless cavity oil circuit to extend all the cylinders, and then remove the rodless cavity oil pipe, connect the rod cavity oil pipe and withdraw all the cylinders, and then connect the rodless cavity oil pipe, so that there is no air in the cylinder.