This article mainly introduces:

Saudi Arabia hydraulic cylinder,stroke adjustable cylinder manufacturer,stroke adjustable cylinder

(Saudi Arabia stroke adjustable cylinder,produced by Hengyu Hydraulic Co., Ltd）

stroke adjustable cylinder are widely used in Saudi Arabia，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed stroke adjustable cylinder for customers from Saudi Arabia.

Introduction to stroke adjustable cylinder:

If the stroke adjustable cylinder piston rod is found to be worn, it can be brushed and plated first, then ground, and finally adjust the mating accuracy of the piston rod and the guide sleeve. At this time, the guide sleeve can be properly redrilled or the guide sleeve can be re-turned. When making the above repairs, remember to replace various rubber seals in time.

When installing the stroke adjustable cylinder, the axial ends of the stroke adjustable cylinder cannot be fixed. Due to the effect of liquid pressure and thermal expansion in the stroke adjustable cylinder, there is axial expansion. If the two ends of the stroke adjustable cylinder are fixed, all parts of the stroke adjustable cylinder will be deformed. When disassembling the stroke adjustable cylinder, it is strictly forbidden to hammer the stroke adjustable cylinder and the piston surface, such as the stroke adjustable cylinder hole and the piston surface is damaged, do not allow sandpaper grinding, to use a fine oil stone carefully grinding. The clearance between the guide sleeve and the piston rod should meet the requirements.

The stroke adjustable cylinder should be used as far as possible to avoid the transverse force, sometimes the piston rod to bear the transverse load is too large, especially do not force or pull the stroke adjustable cylinder, bite. Elimination method: When installing the stroke adjustable cylinder, ensure that the axis position of the stroke adjustable cylinder is consistent with the direction of movement; Make the load borne by the stroke adjustable cylinder as far as possible through the stroke adjustable cylinder axis, to avoid the phenomenon of eccentricity.

Factors that should be considered when selecting the oil seal in the stroke adjustable cylinder: some specific factors should be taken into account when selecting the oil seal in the stroke adjustable cylinder, so as to have correct consideration and get accurate results, and then avoid wrong selection. The factors and aspects that should be taken into account are eight: stroke adjustable cylinder diameter, piston rod diameter, piston rod and piston groove size, stroke adjustable cylinder working pressure, stroke adjustable cylinder movement speed, hydraulic system oil temperature and stroke adjustable cylinder working environment.

Answers to some questions about stroke adjustable cylinder:

What does cylinder speed ratio mean?
The speed ratio of the cylinder is the ratio of the reciprocating speed of the piston, equal to the ratio of the rodless cavity area to the roded cavity area.

The pressure gauge of the hydraulic station reaches 20MPa. How many tons of weight can the hydraulic cylinder lift? How to convert?
20Mpa=200kg/cm^2 The weight of the cylinder with a cross-sectional area of 1 square centimeter can be lifted is 200kg, so F=200X3.14X (125/2) ^2 =24531kg =24.5 tons.