This article mainly introduces:

Luxembourg hydraulic cylinder,shearing machine cylinder manufacturer,shearing machine cylinder

(Luxembourg shearing machine cylinder,produced by Hengyu Group）

shearing machine cylinder are widely used in Luxembourg，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed shearing machine cylinder for customers from Luxembourg.

Introduction to shearing machine cylinder:

The shearing machine cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the shearing machine cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the shearing machine cylinder wall due to the stiffness and the weight of the parts, causing scars.

When the shearing machine cylinder is in use, once the seal and guide support ring are found to be defective, the seal with the same structural form and appropriate material should be replaced according to the structural form of the shearing machine cylinder seal to be repaired, so as to minimize the thickness of the oil film between the seal and the sealing surface and reduce the leakage of the seal.

Do not regularly check the damage of the chrome layer of the shearing machine cylinder: completely extend the shearing machine cylinder and carefully check whether there is any surface damage such as injury, strain, welding slag, such as the surface damage position, in the shearing machine cylinder block < 20cm, and the damage depth < 5mm, should be repaired in time to prevent long-term damage to the shearing machine cylinder seal. Welding slag is strictly prohibited on the surface of the shearing machine cylinder.

After the shearing machine cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.

Answers to some questions about shearing machine cylinder:

How long can a hydraulic cylinder work continuously?
If the maintenance is good, the service life can be extended a lot. The life of the cylinder is related to the structure of the cylinder, working pressure, stress state, hydraulic oil cleanliness, oil temperature control, maintenance and preventive measures. For example, the cylinder structure, the inner wall of the cylinder has quilting, rolling, chrome plating and other methods, the sealing parts have polyurethane rings, glay rings, metal sealing rings, etc., different combinations, the life difference is dozens of times. Metallurgical system is a typical cylinder application, in 24 hours of work, a year or more can not be shut down, in the middle of continuous work.

What is the pressure provided for a 63-bore cylinder with a pressure of 2 mpa?
2 mpa pressure is equivalent to 20 kg per square centimeter, 6.3 cm straight longitude, 3.15 cm radius, square, multiplied by, calculated an area of about 31.5 square centimeters, multiplied by 20 kg, the pressure is about 630 kg.