This article mainly introduces:

Chile hydraulic cylinder,shearing machine cylinder manufacturer,shearing machine cylinder

(Chile shearing machine cylinder,produced by Hengyu Group）

shearing machine cylinder are widely used in Chile，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed shearing machine cylinder for customers from Chile.

Introduction to shearing machine cylinder:

When the shearing machine cylinder is installed, the piston and the shearing machine cylinder head and other parts have large mass, large size and large inertia, even if there is a lifting equipment auxiliary installation, because the specified clearance is small, no matter how hard it will be put into, therefore, the end of the piston or the shearing machine cylinder head boss is easy to cause scars when it hits the inner surface of the shearing machine cylinder wall. The solution to this problem: for a large number of small products, the use of autocratic assembly oriented tools during installation; For heavy, thick and large large and medium-sized shearing machine cylinders, only careful and careful operation can be avoided.

In order to ensure the service life of the shearing machine cylinder, the medium used must not be mixed with impurities and stolen goods, so as to avoid scratching the inner arm of the shearing machine cylinder, causing damage to the seal and causing leakage in the shearing machine cylinder. It is required that the filtration accuracy of the system is not less than 80μm, the oil pollution is strictly controlled, the hydraulic oil is kept clean, the performance of the hydraulic oil is regularly checked, and the necessary fine filtration or replacement of the new working hydraulic oil is carried out.

The material of the sliding part of the shearing machine cylinder piston sintered casting piston will cause sintering phenomenon when subjected to large transverse load. In this case, the sliding part of the piston should be made of copper alloy or welded to such material.

After the shearing machine cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.

Answers to some questions about shearing machine cylinder:

Are hydraulic cylinders divided into oil cylinders and water cylinders? What's the difference between the two types?
There are oil cylinders and water cylinders. The two cylinders are used in different environments. Oil cylinders are generally used in places where there is less demand for media, which is our most common hydraulic cylinders. Water cylinders are mainly used for large tonnage presses. Because the equipment is too large, the use of hydraulic oil will cause a relatively large waste. However, water is not pure water, there are oil-in-water emulsion and water-in-oil emulsion. Water has another benefit: it's flame retardant. It is especially suitable for some flammable and explosive occasions. Or with water glycol. The use of pure water is very little, mainly because the seal is not good and easy to rust.

What are the standard cylinder models for hydraulic cylinders?
National standard GB/T2348-1993 specifies the hydraulic cylinder inner diameter series, you can check GB/T2348-1993 relevant regulations.