This article mainly introduces:

Australia hydraulic cylinder,single rack cylinder manufacturer,single rack cylinder

(Australia single rack cylinder,produced by Hengyu Hydraulic Co., Ltd）

single rack cylinder are widely used in Australia，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed single rack cylinder for customers from Australia.

Introduction to single rack cylinder:

Factors that should be considered when selecting the oil seal in the single rack cylinder: some specific factors should be taken into account when selecting the oil seal in the single rack cylinder, so as to have correct consideration and get accurate results, and then avoid wrong selection. The factors and aspects that should be taken into account are eight: single rack cylinder diameter, piston rod diameter, piston rod and piston groove size, single rack cylinder working pressure, single rack cylinder movement speed, hydraulic system oil temperature and single rack cylinder working environment.

Before purchasing the single rack cylinder, it is necessary to master the original information and design basis, mainly including: the use and working conditions of the machine; The structural characteristics, load conditions, stroke size and operation requirements of the working mechanism; The selected working pressure and flow of the hydraulic system; The reality of materials, fittings and processes; Relevant national standards and technical specifications, etc.

When installing the single rack cylinder pipe, the pipe should be cleaned after installation, and should not pass through the single rack cylinder block, and the by-pass pipe must be installed in front of the oil port of the single rack cylinder block. This is important. Otherwise, the foreign body in the pipeline will enter the single rack cylinder, and once it enters, it is difficult to exclude it, but it becomes a foreign body transported to the single rack cylinder. Moreover, when cleaning, the removal method of foreign bodies entered in the installation pipeline operation should be considered. In addition, the corrosion in the pipe should be pickling and other procedures before the pipe installation, and the rust must be completely removed.

single rack cylinder hydraulic oil selection: The recommended working oil viscosity of the single rack cylinder is 10 ~ 110cSt (1.8 ~ 15E), ISO VG46 hydraulic oil. The normal working oil temperature is 10 ~ 70℃, and the ambient temperature is in the range of -20 ~ 80℃. When the ambient temperature and service temperature are low, the hydraulic oil with lower viscosity can be selected.

Answers to some questions about single rack cylinder:

What is the valve on the hydraulic cylinder?
Oil valve, relief valve, overload valve, explosion-proof valve, etc., these are very convenient to insert! The oil valve, the overload valve and the blasting valve are very important for larger cylinders. Manufacturers will not offer you the selection. You need to choose the values by yourself according to your system, pump, cylinder, environment, working conditions and other comprehensive consideration!

What is the function of the hinged cylinder of the shield machine?
The articulated cylinder is used for the shield when the radius of curvature is very small during the propulsion process, that is, for turning. For example, a propulsion section with a radius of curvature of R150 can only be turned using an articulated system due to the sensitivity of the shield body (i.e. the length of the shield body divided by its outside diameter). However, in the construction process, the use of articulated systems is not much.