This article mainly introduces:

Thailand hydraulic cylinder,displacement sensor cylinder manufacturer,displacement sensor cylinder

(Thailand displacement sensor cylinder,produced by Hengyu Hydraulic Co., Ltd）

displacement sensor cylinder are widely used in Thailand，because of long service life，smooth movement，high work efficiency.So our company has designed displacement sensor cylinder for customers from Thailand.

Introduction to displacement sensor cylinder:

Do not regularly check the damage of the chrome layer of the displacement sensor cylinder: completely extend the displacement sensor cylinder and carefully check whether there is any surface damage such as injury, strain, welding slag, such as the surface damage position, in the displacement sensor cylinder block < 20cm, and the damage depth < 5mm, should be repaired in time to prevent long-term damage to the displacement sensor cylinder seal. Welding slag is strictly prohibited on the surface of the displacement sensor cylinder.

In the process of using the displacement sensor cylinder, sometimes such a problem will occur, the displacement sensor cylinder can not act immediately after the instruction of the displacement sensor cylinder action is issued, and it must be moved after a short time, or sometimes it can move and stop moving, showing that the operation is very irregular. The cause and elimination of this failure mainly include air in the oil displacement sensor cylinder. Elimination method: exhaust through the exhaust valve. Check the piston rod reciprocating parts of the sealing ring for air inhalation, if so, replace the sealing ring.

Disassembly displacement sensor cylinder: When disassembly displacement sensor cylinder, strictly prevent damage to the screw thread at the top of the piston rod, the screw thread of the displacement sensor cylinder head and the surface of the piston rod. It should also be noted that the piston cannot be played out from the displacement sensor cylinder.

displacement sensor cylinders in series, parallel and series parallel. Series: In the displacement sensor cylinder, the oil inlet of the subsequent reversing valve is the supply of the previous oil return, and there is no separate oil return circuit connected with the oil return in each valve. Series: In the displacement sensor cylinder, the oil inlet of the subsequent reversing valve is the supply of the previous oil return, and there is no separate oil return circuit connected with the oil return in each valve. Parallel: the pressure oil in the displacement sensor cylinder is connected with the inlet oil of each reversing valve, and the return oil is collected by the return oil circuit. Series parallel: For this one, compared with the simple series and parallel, it is slightly more complicated, but it is not impossible to understand. The series refers to the oil in the displacement sensor cylinder, which is in series form, but can not form a series circuit, and the parallel refers to the oil return circuit of each valve, which is in parallel.

Answers to some questions about displacement sensor cylinder:

Cylinder la-50-70st What does that mean?
Full model should be CX-LA-50-70ST, thin block cylinder, radial mounting, bore 50, stroke 70.

How many boom cylinders, bucket rod cylinders and bucket cylinders are there in a small single-bucket excavator?
one for bucket, one for forearm, only one piece for a small excavator under the big arm, two pieces for medium and large excavator.