This article mainly introduces:

America hydraulic cylinder,tailboard balance cylinder manufacturer,tailboard balance cylinder

(America tailboard balance cylinder,produced by Hebei Hengyu company）

tailboard balance cylinder are widely used in America，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed tailboard balance cylinder for customers from America.

Introduction to tailboard balance cylinder:

When the tailboard balance cylinder wear is serious, you can try to use an alloy scraper to shave grooves with a depth of more than 1mm on the surface of the slip injury, then clean the grooves with acetone, apply the adjusted TS311 anti-wear repair agent on the polished surface with the tailboard balance cylinder inner diameter copying plate, and scrape it flat vigorously to ensure compaction and higher than the inner surface of the tailboard balance cylinder. After curing, polish to leave a finishing margin. Finally, the overall size, shape tolerance and roughness of the tailboard balance cylinder can meet the requirements by grinding. However, the life and reliability of this repair tailboard balance cylinder are not high.

The material, shape and compression of the tailboard balance cylinder seal have a great impact on the service life and work efficiency of the tailboard balance cylinder. In addition to requiring a reliable seal, it should also have a long service life and less friction loss. At present, there are many seal manufacturers in the country, and it is also crucial to choose high-quality seals with reliable and stable quality.

When producing oil tailboard balance cylinders, there are two processing processes, grinding and rolling, the latter is better than the former. Rolling machining is a kind of non-cutting machining, using the plastic deformation of the metal at room temperature, so that the micro roughness of the workpiece surface is flattened to achieve the purpose of changing the surface structure, mechanical characteristics, shape and size. Therefore, this method can achieve the two purposes of finishing and strengthening at the same time, which can not be done by grinding.

After the tailboard balance cylinder is installed, lubricating grease should be added to the relative moving parts such as earring and middle hinge shaft before trial operation.

Answers to some questions about tailboard balance cylinder:

Slide weight 35 kg exit stroke 55mm, is it suitable to use 40 cylinder diameter cylinder?
The maximum output force of the 40-bore hydraulic cylinder can reach 2 tons, and whether it can be used depends on the use scenario. In addition, the problem of mechanism stuck has nothing to do with the size of the power source, and reasonable structural design and good machining and assembly accuracy are the key.

How to judge the failure of forklift hydraulic cylinder?
The common faults of the hydraulic cylinder of forklift truck are mainly crawling, insufficient thrust, working speed decline or even stop. Generally, crawling occurs at low speed. The main reason is that the air stored in the cylinder is not cleared. In addition, excessive or uneven mechanical friction can also cause crawling. Such as the piston and the piston rod different heart, the piston rod full length or local bending, the cylinder hole straightness is poor, the cylinder is drum shaped or has a large taper, the cylinder thin finish decline or produce hair, the cylinder installation accuracy is out of whack, the piston rod nuts at both ends of the screw too tight to make its concentricity is poor, the oil seal screw too tight friction is too large, will cause crawling.