This article mainly introduces:

Bolivia hydraulic cylinder,stacker cylinder manufacturer,stacker cylinder

(Bolivia stacker cylinder,produced by Hengyu Hydraulic Co., Ltd）

stacker cylinder are widely used in Bolivia，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed stacker cylinder for customers from Bolivia.

Introduction to stacker cylinder:

The difference between the integral stacker cylinder and the split stacker cylinder: The integral stacker cylinder and the split stacker cylinder in the stacker cylinder are two different stacker cylinders, and they are very different. The whole stacker cylinder, which is cast in one body, is not prone to problems such as oil leakage; The split stacker cylinder is welded twice, so if it is not handled well at the welding, it is prone to problems such as oil leakage and stacker cylinder damage. Therefore, it is obvious that the answer to this question is for difference.

The body of the stacker cylinder on the processing process requirements: the body of the stacker cylinder is an important and essential part of the stacker cylinder, because it has an irreplaceable role. The processing requirements for this part are very high, requiring that the surface roughness of the stacker cylinder after processing should reach 0.4-0.8um, and the coaxiality and wear resistance requirements are also very high.

In the case of serious wear on the inner surface of the stacker cylinder, or when there is a deep longitudinal tensile mark, it should be mapped according to the physical object and re-produced by the professional manufacturer according to the stacker cylinder manufacturing process for replacement. The stacker cylinder can also be repaired with TS311 antiwear repair agent. TS311 anti-wear repair agent is mainly used for the repair of worn and slipped metal parts.

The stacker cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the stacker cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the stacker cylinder wall due to the stiffness and the weight of the parts, causing scars.

Answers to some questions about stacker cylinder:

How to calculate the tonnage of hydraulic cylinder? The tonnage of the cylinder refers to the output force of the cylinder under rated working pressure: 1, for single rod piston hydraulic cylinder, it can be calculated by the area of the circle corresponding to the inner diameter of the cylinder A (square centimeter), and the rated working pressure of the system p (mpa), the value is equal to 10pA kg force, and the ton is 0.01pA. 2, for the double rod piston hydraulic cylinder, with A(square centimeter) to indicate the cylinder cylinder diameter and piston rod outer diameter defined by the ring area, with p (mpa) to indicate the rated working pressure of the system, the output force of the cylinder is 0.01pA ton force.

When does the cylinder rotate?
The piston rod inside the multistage plunger cylinder can be rotated, and it will rotate when it is subjected to tangential force.